Thread: iAtkos S3 v2 Installed rebbot on loop Problem

Hy guys i finish to install Iatkos S3 V2 on my Asus X52j Series but when my pc reboot after installation pc start with an err... ""Boot0 = err"" or samthing look like this but isnt a soo big problem i start it with the Iatkos DVD installation and i chose mac or windows windows start perfectly but mac no why i see for 1 seccond apple logo but why system was succesfull installed same peapole knoq what will be problem or sameone know same command for start it please

here is my pc information

Asus X52j Series

PC information
http://img406.imageshack.us/img406/1...inebitmapx.png

Graphic video Radeon HD 6370M 512MB

post all you think i can do thanks all for ho help me i give a donation or forum donation all you whant but please same one hlp me

Check on your device manual if your Hard Disk Drive haves 4k sectors...

If yes, try this > Issue 129: boot0 error on HDDs with 4K sectors - Chameleon open source boot loader project.

You need to manually install "boot1h" (for HFS Filesystem) or "boot1f32" (for FAT32 Filesystem) from Terminal of a Linux LiveCD to your OS X partition...

For example, if you use a Ubuntu LiveCD, the command will be something like the below...

Code:

sudo dd if=boot1h of=/dev/sdXY bs=4096

X = Disk Letter

Y = Partition Number

sry i didnt understand what code i need to start to enter on my system opertaion???

Originally Posted by Whyroph

sry i didnt understand what code i need to start to enter on my system opertaion???

If you have only "one" disk attached to your machine and "only" OS X installed on it on the "GUID" partition scheme, the command will be the below...

Code:

sudo dd if=boot1h of=/dev/sda2 bs=4096

worck for iatkos s3 v2 and no i have 2 hard disk

Originally Posted by Whyroph

worck for iatkos s3 v2 and no i have 2 hard disk

This is not a matter of "Software", but "Hardware"...

If your HDD haves 4k sectors you need to follow the steps above...

If your HDD haves 512b sectors just reinstall Chameleon again using a different installer...

differnet installer exeple what can you show me a link??

http://www.osx86.net/view/2377-chame...r1815.pkg.html

i have also problem with this iAtkos S3 v2, after installing my graphics card didnt work for me..
only 1024x768., audio working but not enhanced also the Ethernet working.

any ideas?

BTW: my graphics card is evga geforce gt430 1gb DD3

Whyroph: at the boot prompt when it gives you the choice of Windows or Mac click once on the mac one. Then type:

-v -f cpus=1 busratio=20 arch=i386 GraphicsEnabler=Yes PCIRootUID=1

this should (I hope) get you started. The capitals are important, the bootloader is case sensitive.