Thread: restart computer when log in mac ofter install iAtkos s3

hi


I'm install iAtkos S3 v2 on my PC.Installation done with no problem,but,when I restart at end of installation and want to log in mac ... my computer restarted without any message.
I use "-v","cpus=1","-x" and... and problem dont solved.
please HELP ME...

detials :

Code:

cpu: Intel(R) Celeron(R) D CPU 3.20GHz
mainboard : Gigabyte Technology Co., Ltd. 8I865PE775-G F1
RAM: 1024 MBytes DDR
Graphics: fx 5500 GeForce


Customize: 

BootLoader : Chameleon v2 RC4
Bootloader Options: 32-bit boot , Graphics Enabler
pathches: (default)
Drivers:
	Main Hardware:
		SATA/IDE: Intel SATA/IDE
		sound: (default)
		ps/2: Apple PS/2
		CPU Power Management: Voodoo P-State

when I logo in iAtkos with "-v" this message apeare at the end of lines ,then restart:

Code:

nVidia GeForce Fx 5500 256MB NV34[10de: 0326] :: PciRoot(0x0)/Pci(0x1,0x0)/Pci(0x0,0x0)
No SMBIOS replacement found.
Patched DMI Table.
No DSDT replacement found.Leaving ACPI data as is
Starting Drawin x86

What motherboard are you using?

Gigabyte Technology Co., Ltd. 8I865PE775-G F1

This support all requirements for iAtkos s3 v2.

Sorry, not familiar with relatively old hardware. It's a P4 right?

yes ,this is for 2006.

hey!!! need some help!!!
i did an installation of iatkos s3 v2 on my pc, the specs:

MOBO: dh55pj classic series
Processor: intel core i3 3.06mhz
video: ECS Nvidia 8400gs Silent 512mb
Ram: 4gb ddr3

the problem here is that a few days ago i did the installation like 3 times or something, and in one of the attempts it worked, but i think i mistake in the kexts installation because when i installed the vinject kext it showed me a kernel panic, so, i did not know what to do and tried to install everything again (i mean the whole installation of iatkos) but since that day it only shows me this log in verbose mode (-v), (in -f or -s it just do the same of verbose mode)

nVidia unknown 512mb (etc)
No SMBIOS replacement found.
Patched DMI Table.
No DSDT replacement found.Leaving ACPI data as is
Starting Drawin x86

if i try to boot in normal mode it restart just when the apple logo appears on screen, when i try to boot in safe mode (-x) it just freezes at apple's logo.
i hope somebody can help me with this, i can´t understand how this could be posible that one day the installation goes fine but the other days it just don´t, even if i select different drivers and stuff everytime i try to install, please help!!
PS sorry for my english je